Tap Repair & Replacement in Glasgow

Vetted & insured engineers Clear pricing before work starts G3-qualified for unvented cylinders No gas work — plumbing only

A tap that won't turn off is a small emergency; a tap that drips is a slow one. Either way, our Glasgow engineers arrive with cartridges, washers, O-rings and flexible connectors on the van.

Glasgow water notes: Glasgow's water from Loch Katrine is among the softest city supplies in Britain — limescale is a non-issue, though the city's older pipework and cold winters keep burst and freeze work steady. The tenement defines Glasgow plumbing: shared closes, communal stacks, and Victorian pipe runs serving stacked flats — meaning one flat's leak is quickly three flats' problem, and access etiquette is part of the job. Mains supply here is managed by Scottish Water.

Repairs: washers, cartridges and seals

Traditional compression taps drip because the washer or seat has worn — a re-washer and reseat is a fast, cheap repair. Ceramic disc taps (most modern mixers and quarter-turn taps) drip because the cartridge has worn or scaled; we carry common cartridge sizes and match obscure ones by manufacturer. O-rings cure leaks from the spout base and handles. In Glasgow's water, scale accelerates all of this — which also means a serviced tap lasts visibly longer than a neglected one.

Replacement done properly

When we replace a tap in Glasgow, isolation valves go in as standard if there are none — future repairs then take minutes and no draining down. Old flexis are replaced rather than reused, back-nuts get proper tools rather than swearing, and monoblocs are stabilised with the correct fixing kit so the tap doesn't work loose in a month. You can supply your own tap or choose from ranges we stock.

The real cost of a drip

That background drip is a running bill: thousands of litres a year, doubled in cost on a meter (supply plus sewerage), tripled in annoyance. Hot-side drips also drain your cylinder's heat. In Glasgow's water the drip also leaves scale tracks that etch chrome and stain ceramics — cosmetic damage that outlasts the fault.

Tap work pricing in Glasgow

Repairs from £79 including standard parts; replacement labour is a fixed band with the tap itself either supplied by you or itemised by us. Awkward access — seized fittings, no isolation, corroded traps in the way — is flagged before work continues, never billed as a surprise. All Glasgow pricing is confirmed before the engineer starts.

Frequently asked questions

Do you fix outside taps?

Yes — repairs, replacements and new outside tap installations with the legally required double-check valve for backflow prevention, plus an internal isolation point so you can drain it each winter.

Can you fit a tap I bought online?

Yes — supply-your-own is fine and priced at the same labour rate. We'll check compatibility (tail lengths, hole spacing, pressure requirements) before removing the old tap, so a mismatch is caught before the sink is out of action.

Why does my tap still drip after a new washer?

Either the tap seat is scored (needs reseating or a seat insert), or the tap is actually a ceramic cartridge type where washers aren't the wear part. Persistent drips after DIY usually mean the wrong diagnosis, not a bad washer.

Can you match a cartridge for an unbranded tap?

Usually — cartridges follow common sizes (25mm, 35mm, 40mm) and spline patterns, and we measure and match. Genuinely obsolete taps do exist, and we'll tell you when replacement is the economic answer.