Tap Repair & Replacement in Islington

Vetted & insured engineers Clear pricing before work starts G3-qualified for unvented cylinders No gas work — plumbing only

From period pillar taps in Angel to monobloc mixers in Old Street kitchens, we repair and replace taps across Islington, and we'll tell you honestly when a repair beats a replacement.

Islington water notes: Islington gets the full hard-water London experience — limescale shortens element life and chokes shower heads, which matters in a borough this dense with converted period flats. Islington's Georgian and Victorian terraces — Barnsbury, Canonbury, Highbury — are overwhelmingly divided into flats, so stacked services, shared stopcocks and neighbourly leak diplomacy are standard features of the work. Mains supply here is managed by Thames Water.

Repairs: washers, cartridges and seals

Diagnosis by symptom: a steady drip from the spout is a washer (compression taps) or cartridge (ceramic disc); leakage around the base of a swivel spout is O-rings; a handle that turns without resistance is a stripped head or spline; banging pipes when the tap closes is water hammer, cured with an arrestor or pressure adjustment rather than a new tap. Each is a stocked-part fix for our Islington engineers. Islington gets the full hard-water London experience — limescale shortens element life and chokes shower heads, which matters in a borough this dense with converted period flats.

Replacement done properly

When we replace a tap in Islington, isolation valves go in as standard if there are none — future repairs then take minutes and no draining down. Old flexis are replaced rather than reused, back-nuts get proper tools rather than swearing, and monoblocs are stabilised with the correct fixing kit so the tap doesn't work loose in a month. You can supply your own tap or choose from ranges we stock.

The real cost of a drip

One drip per second is roughly 5,500 litres a year — on a metered Islington supply, that's paid for twice, as water and as sewerage. Hot taps are worse: every drip carries heating cost too. A £75 repair typically pays for itself within months on a metered hot tap, before counting the staining and scale damage to the sink below.

Tap work pricing in Islington

Repairs from £75 including standard parts; replacement labour is a fixed band with the tap itself either supplied by you or itemised by us. Awkward access — seized fittings, no isolation, corroded traps in the way — is flagged before work continues, never billed as a surprise. All Islington pricing is confirmed before the engineer starts.

Frequently asked questions

Do you fix outside taps?

Yes — repairs, replacements and new outside tap installations with the legally required double-check valve for backflow prevention, plus an internal isolation point so you can drain it each winter.

My mixer tap has low pressure on hot only — why?

Common on combi and gravity systems: scale or a blocked hot-side inlet filter, a kinked or degraded flexi, or the tap's internal flow restrictor. It's diagnosable in minutes with the tap head off.

Is a constantly dripping tap really worth fixing?

On a metered supply, unambiguously: thousands of litres a year, charged as both water and sewerage, plus heating cost on hot taps. The repair usually costs less than the annual waste.

Can you fit a tap I bought online?

Yes — supply-your-own is fine and priced at the same labour rate. We'll check compatibility (tail lengths, hole spacing, pressure requirements) before removing the old tap, so a mismatch is caught before the sink is out of action.